The PAN4570 is a short range, low power, 2.4 GHz ISM band transceiver using the Ember EM250 single chip solution. With IEEE 802.15.4 compliance, 16-bit ZAP2b micro-processor, on-board reference oscillators, and optimized RF front-end circuitry, the PAN4570 provides everything needed for a mesh networking solution. A reliable application programming interface, Ember's EmberZNet stack can easily create application profiles.

Applications

  • Remote Control And Wire Replacement In Industrial Systems Such As Wireless Sensor Networks
  • Factory Automation / Motor Control
  • Home Automation
  • Lighting Control
  • RFID Tagging
  • Inventory Management
  • Automated Meter Reading
  • Monitoring (Environmental, Patient or Fitness) 

Product Performance

  • 128k Flash And 5k SRAM Memory
  • 3 Antenna Options: Plug, 50Ω SMD Port Or Ceramic Antenna
  • 16 Selectable Channels With 250 kBps In The 2.4 Ghz Band
  • 3 Different Power Modes For Increased Battery Life
  • High Sensitivity Of -97 dBm Typical At A 1% Packet Error Rate
  • +3 dBm Output Power (+5 dBm In Boost Mode)
  • Low Supply Voltage (2.1 V To 3.6 V, 3.0 V Typical)
  • Small Size: 20.0mm X 26.5mm X 3.0mm
  • Onboard Low Power Regulator
  • Operating Temperature Range: -40°C To +85°C
  • Link Quality And Clear Channel Assessment Capability
  • All Of The 17 GPIO Of EM250 Are Available At The Module Pads, Which Are Multiplexed To GPIO, UART, SPI, I2C Or Up To Four Analog Inputs To An ADC And Two Timer Waveform Outputs
  • Critical Portions Of IEEE 802.15.4-2003 Plus A First-line Filter For Non-Intended Packets Are Realized In Hardware, Thus Reducing The Workload On The uc
  • FCC Certified 
Series PIM ID
90951